根據intel nic teaming白皮書
你可以有這些合併選項
部份需要switch也提供相應功能才可以work
你的狀況只是要上網
除非你是牽100M以上的光纖上網
不然用不到合併選項
解掉吧

1.2.3.1 Adapter Fault Tolerance (AFT)
Adapter Fault Tolerance provides automatic redundancy for your server’s network connection. If the
primary port fails, the secondary port takes over. AFT supports two to eight ports per team. This
teaming mode works with any switch, and all team members must be connected to the same network.
While AFT will also work with hubs, it is only recommended for troubleshooting purposes.

AFT is inherent in all teaming modes. This mechanism is present as the basis for each of the following
teaming modes.
1.2.3.2 Switch Fault Tolerance (SFT)
Switch Fault Tolerance (SFT) provides a failover relationship between two ports when each port is
connected to a separate switch. SFT supports two ports per team. Spanning Tree Protocol (STP) must
be enabled on the switch except that the ports connected to the teamed ports should have Port Fast or
Edge Port enabled. This teaming mode works with any switch.
1.2.3.3 Adaptive Load Balancing (ALB)
Adaptive Load Balancing (ALB) provides load balancing of transmit (outbound) traffic. By default
ALB also includes Receive Load Balancing (RLB). Together these two teaming modes permit load
balancing in both transmit and receive directions. RLB can be independently disabled. This teaming
mode works with any switch.
1.2.3.4 Static Link Aggregation (SLA) – FEC, GEC, Static IEEE 802.3ad
Static Link Aggregation accounts for the FEC, GEC and 802.3ad static protocols. SLA is a switch-
assisted teaming mode and requires configuring ports at both ends of the link: server interfaces and
switch ports. This is often referred to as Cisco Fast EtherChannel or Gigabit EtherChannel. In addition,
SLA supports similar implementations by other switch OEMs such as Extreme Networks Load Sharing
and Bay Networks or IEEE 802.3ad Link Aggregation static mode.
1.2.3.5 Dynamic Link Aggregation (DLA) – LACP (IEEE 802.3ad)
Dynamic Link Aggregation (DLA) is similar to SLA except that it uses the Link Aggregation Control
Protocol to negotiate the ports that will make up the team. LACP must be enabled at both ends of the
link for the team to be operational. This teaming mode requires a switch that fully supports the IEEE
802.3ad standard.