Officially there can only be 1 LM90 on a PC, however it is possible so make it switch between 2 CPU's, this is something IWill has done with their MPX2, if you want to use this feature then make sure you 1st set your current LM90's to none, next apply and close MBM then do the part below and you will see 4 instead of 2 LM90 sensors, 2 remote and 2 local

If you want to select all 4 then I recommend you it like this:

LM90-1-Local
LM90-1-Remote
LM90-2-Local
LM90-2-Remote

and not mix the 1 and 2 up, it will only make problems and I also suggest you don't go lower then 5 seconds with the MBM interval

Edit the MBM 5.ini file and find the [ADVANCED] section, add/change the line LM90 Switch=X where X is a number between 1 and 24. Warning: do not set a random number, stick to the table below !!!!!

Board Value of X
IWill MPX2 1

The switching of the LM90 and reading it out right away might -in some cases- be to fast for the LM90 to get a new value from the "other" CPU, if this is the case you should see the temperature of a CPU jump at time to the same value of the other CPU.

If this is happening than you can include a pause, this will slow MBM a little down but might be what you need.

Edit the MBM 5.ini file and find the [ADVANCED] section, add/change the line LM90 Pause=X where X is a number between 1 and 500 and represents the miliseconds that MBM should pause after a switch, 500 = 1/2 second

有沒有人可以解釋一下..上面說的要如何設定.!我有看沒有懂..