引用:
|
作者k83d
這兩天因為電腦掛了，所以換了新主機，主機內容是Q8200+P5Q-E+金士頓1G，想說要小超一下，進入BIOS之後傻眼了，完全找不到外頻跟倍頻在哪裡 
我之前用的版子只要進去了以後，把CPU的選項AUTO改掉就會出現外頻跟倍頻可以選，而P5Q-E這一塊我把Ai Overclock改成Manul之後我去下面找了半天還是沒看到，記憶體選項也多了好幾項 
所以想拜託一下各位前輩，有沒有人可以教一下小弟我該如何設定，感激不盡 
PS:我大概也有爬一下文，可是版上的前輩幾乎都是貼結果出來，詳細的步驟幾乎都沒有提到，所以實在很難看懂，我知道我這樣的問題或許有些白目，但還請各位大大多包涵  |
之前在滄者那里看見有人發表針對P5Q-E衝500外頻的超頻詳細設定,你參考下:
JumperFree Configuration Settings
AI Overclock tuner: Manual
CPU Ratio Setting: 6
FSB Strap to North Bridge: auto
FSB Frequency: 590
PCI-E Frequency: 100
DRAM Frequency: 1180
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: Manual
1st Information :
CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15
RAS# to RAS# Delay : A
Row Refresh Cycle Time: A
Write Recovery Time:A
Read to Precharge Time: A
2nd Information :
READ to WRITE Delay (S/D): A
Write to Read Delay (S): A
WRITE to READ Delay (D): A
READ to READ Delay (S): A
READ to READ Delay (D): A
WRITE to WRITE Delay (S): A
WRITE to WRITE Delay (D): A
3rd Information :
WRITE to PRE Delay: A
READ to PRE Delay: A
PRE to PRE Delay: A
ALL PRE to ACT Delay: A
ALL PRE to REF Delay: A
DRAM Static Read Control: D for OC, E for performance
DRAM Read Training: D for OC, E for performance
MEM. OC Charger: E
AI Clock Twister: A
AI Transaction Booster: Manual, or auto
Common Performance Level :
Pull-In of CHA PH1: DISABLED
Pull-In of CHA PH2: DISABLED
Pull-In of CHA PH3: DISABLED
Pull-In of CHA PH4: DISABLED
Pull-In of CHB PH1: DISABLED
Pull-In of CHB PH2: DISABLED
Pull-In of CHB PH3: DISABLED
Pull-In of CHB PH4: DISABLED
CPU Voltage: depends
CPU GTL Voltage Reference (0/2): AUTO
CPU GTL Voltage Reference (1/3): AUTO
CPU PLL Voltage: 1.50V ~1.54
FSB Termination Voltage: 1.20V~1.24
DRAM Voltage: 2.14V~2.25v(1100~1200+)
NB Voltage: 1.40v for 575+
NB GTL Reference: AUTO
SBridge Voltage: 1.10V
PCIE SATA Voltage: 1.50V
Load Line Calibration: Disabled or enable
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : 100~300ps
NB Clock Skew : 100ps
Advance CPU Settings
CPU Ratio Setting: Manual
CPU VID: Default
C1E Suppport: Disabled
Max CPUID Value Limit: Disabled
IntelR Virtualization Tech: Disabled
Vanderpool Technology: Disabled
CPU TM Function: Disabled
Execute Disable Bit: Disabled