補充：

創造 EAC 的 Andre Wiethoff 在他寫的 FAQ 中建議用 burst mode 抓取難纏片的音軌，引三則於下：

Q: I had ripped other records, they extracted fine. But there was one CD, where the ripping was desperately slow and the peak level of what I got was always 0%. Sometimes I got "Sync Errors". I tried several times without success. What can I do then?

A: Have a look on the CD if it is dirty. Try to clean it (from the inner ring to the outer bound), perhaps it works better then. If not, try to lower speed or even to extract in burst mode, sometimes this will give better results (but no error reporting though).



Q: I only get many pops and clicks when extracting a very badly scratched CD in secure mode, what can I do?

A: It could possible to revive them by copying them in burst mode to hard disk. The high readout speed keeps the optical system of the drive from following the scratches instead of the audio track. After copying check the copies out, perhaps there were still errors left.



Q: I am getting Sync and Read errors occasionally, but EAC will still finish ripping, though with some "suspicious" positions. What to do now?

A: Clean the CD carefully and try again. If the errors don't go away, listen to the suspicious positions and decide whether they are audible or not. You could also try to rip these tracks in burst mode, sometimes the reader could get better results on these bad sectors.

來源： http://www.exactaudiocopy.de/