|
Junior Member
|
引用:
Originally posted by purejack
我看的是文章,因為你說蠻下面的,我只看了下面兩個,再上面一個才是你說的...@@
我看他說他用50k,不過應該用10k就夠了,因為他調到4.xk
就在那張圖上面有說,他是說完才貼圖的
|
找到了！
這一段
The VDD mod is easy money. The 6520 IC just under the AGP slot, I hooked up a 50k ohm resistor to pin 6 to ground. I think the 50k is an overkill but thats what I used. It actually reads 4.16k ohms right now. I assume a 10k VR would work fine. You measure the VDD off of a mosfet that is near the IC. I personally soldered a wire to the mosfet leg so I could have easy access to read the voltage, it would be impossable to measure when the agp card is in place.
感激！
那就是用一個可變電阻，接在他上面標示的兩隻腳囉？
他還有接出來用電表測量電壓？
不過好像說當AGP插著時，是量不出來的？
晚點去試試看∼
謝謝你的回應！ |