ABIT NF7北橋電壓修改有譜了∼
 

國外網站看到的
http://www.xtremesystems.org/forums...p?postid=108459

原來連結，在蠻下面的∼

不過跟我看的8RDA不太一樣∼
8RDA北橋電壓修改

不過NF7也是在上面那兩個點銲一個可變電阻嗎？
原發文者沒說要用幾歐姆的.......

幫忙推
希望有讀電子科系ㄉ大大們來幫忙

感激兄台相助∼

ohm->歐姆

這個我知道∼
我是想請問要用幾歐姆的......

你是說哪個連結的哪個圖呀?
我看到的都有寫幾歐姆耶...@@
我看錯個了嗎

其實都一樣！
只不過第一個連結我把圖單獨連出來......

你不會看到8RDA那個吧？

我看的是文章,因為你說蠻下面的,我只看了下面兩個,再上面一個才是你說的...@@
我看他說他用50k,不過應該用10k就夠了,因為他調到4.xk
就在那張圖上面有說,他是說完才貼圖的

找到了！
這一段
The VDD mod is easy money. The 6520 IC just under the AGP slot, I hooked up a 50k ohm resistor to pin 6 to ground. I think the 50k is an overkill but thats what I used. It actually reads 4.16k ohms right now. I assume a 10k VR would work fine. You measure the VDD off of a mosfet that is near the IC. I personally soldered a wire to the mosfet leg so I could have easy access to read the voltage, it would be impossable to measure when the agp card is in place.

感激！
那就是用一個可變電阻，接在他上面標示的兩隻腳囉？
他還有接出來用電表測量電壓？
不過好像說當AGP插著時，是量不出來的？
晚點去試試看∼
謝謝你的回應！

應該是吧...我自己也沒改過,不敢給你掛保證...
I personally soldered a wire to the mosfet leg so I could have easy access to read the voltage, it would be impossable to measure when the agp card is in place.
這句話應該是指他是焊了一條線所以能輕易的量測電壓,否則當顯示卡插上去的時候沒辦法量到.